吐纳麝香长期暴露下蚯蚓体内金属硫蛋白和谷胱甘肽变化

吐纳麝香(AHTN)作为人工合成麝香中多环麝香的典型代表,具有挥发性、易生物富集等特性,由于其在环境中的浓度日益升高,呈现出一定的生物效应,可能对生态系统的稳态存在着潜在的威胁,为探讨上述课题,试验通过采用自然土壤法以赤子爱胜蚓(Eiseniafetida)作为试验动物,首次研究测定蚯蚓在AHTN的长期暴露条件下,其体内金属硫蛋白和谷胱甘肽含量的变化。试验结果得出低浓度的AHTN能够抑制机体内金属硫蛋白和谷胱甘肽的生成,使得金属硫蛋白和谷胱甘肽的含量显著减少,在一定浓度范围内的AHTN对机体无明显不利影响,而高浓度的AHTN能够诱导机体内金属硫蛋白和谷胱甘肽的生成,使得金属硫蛋白和谷胱甘肽的含量显著增多(P<0.05),从而对土壤环境存在着潜在的生态风险。     

上海市大气总汞季节变化特征及与气象条件的关系

2008年到2010年对上海市西南部大气中总汞(TGM———Total Gaseous Mercury)的污染水平进行监测,结果表明TGM日均浓度为ND~57.23ng/m(3(7.79±3.29)ng/m)3。TGM呈现出一定的季节性变化特征,浓度最高的是秋季,然后依次是冬季、春季、夏季,平均浓度分别为(9.30±2.48)、(8.32±2.79)、(7.78±2.33)、(2.16±3.29)ng/m3。TGM浓度受东南风向影响最大,其次为西北和东北风向。在置信水平为95%的情况下,TGM浓度与日平均温度呈正相关性,而与日温差、相对湿度、日相对湿度差、风速无显著相关性。但TGM浓度分别与日均O3浓度和NO2浓度均呈显著正相关。利用HYSPLIT_4模型对TGM浓度高值与低值几天的空气气团来源轨迹进行反演,结果发现高低浓度日的气团来源略有差别,总体上看,冬季、春季和秋季受北方气团影响较大,夏季则受我国东部海域影响,具体的局部和长距离输送的贡献需要进一步研究。     

纳米铁酸镍的制备及可见光催化性能研究

利用水热法制备了纳米铁酸镍,表征了其微观结构和光谱性能,并以罗丹明B溶液作为目标污染物,研究了铁酸镍催化剂的可见光催化性能。结果表明:所制备铁酸镍的微观形貌为由直径200-300 nm左右的类似球形小颗粒组成的大颗粒,平均粒径为95.60 nm,在紫外-可见光谱区均有较强的光吸收。光催化过程中催化剂的适宜用量为0.05 g,少量H2O2的加入有助于提高罗丹明B溶液的降解率。催化剂用量为0.05 g,加入0.4 mL 30%的H2O2,降解50 mL 20 mg/L罗丹明B溶液,模拟太阳光照射240 min后降解率能够达到99.2%。在实际太阳光照射下,240 min后罗丹明B溶液的降解率可以达到85.2%。     

锰铈脱硝催化剂的制备及其再生性能研究

采用等体积浸渍法制备了一系列Mn-Ce-Ox复合氧化物脱硝催化剂用于NH3选择性催化还原(NH3-SCR)NO。考察了Mn/Ce摩尔比、焙烧温度、H2O和SO2对Mn-Ce-Ox复合氧化物脱硝催化剂活性的影响及催化剂中毒再生性能。结果表明:当NH3:NO=1:1,空速为5 000 h-1,550℃焙烧制得的Mn/Ce摩尔比为5∶1的Mn-Ce-Ox复合脱硝催化剂活性最佳,活性温度窗口为100~260℃,在此温度区间内催化剂活性大于90%。200℃时,Mn-Ce-Ox复合催化剂活性最高为97.84%;在10%(V/V)H2O蒸汽和300×10-6SO2共存条件下,200℃时,催化剂活性在开始反应2.5 h内迅速下降至53%左右,并在之后的6 h内没有明显变化;中毒催化剂经常温水洗再生处理、质量分数为3%的硝酸溶液再生处理和550℃焙烧2 h再生处理后200℃活性均能恢复到90%以上,其中中毒催化剂经质量分数为3%硝酸处理后活性恢复率最高。     

生物流化床短程硝化的快速启动及影响因素研究

采用内循环生物流化床反应器处理模拟高浓度氨氮废水,以确定其对处理高浓度氨氮废水的可行性,同时对试验条件进行了优化。结果研究表明:控制温度为(31±1)℃,利用反应器自身流化所携带溶解的空气,反应器内DO值可维持在1.5~2.5 mg/L,调节pH为8.0~8.5。经过42 d的污泥驯化适应时期,进水氨氮(NH4+-N)浓度由50 mg/L提高到300 mg/L。由于流化床采用填料载体微生物膜与活性污泥双重作用,同时载体呈流化状态,接触均匀,有巨大的比表面积,可以使床内保持高浓度的生物量,从而达到高效快速的传质效果。在HRT由开始的16 h缩短到8 h的条件下,氨氮(NH4+-N)的去除率达到90%以上,亚硝氮(NO2--N)的积累率达到75%。且在以后30 d的稳定运行阶段,氨氮(NH4+-N)去除率和亚硝氮(NO2--N)积累率均保持稳定。同时反应器最后出水水质澄清,无需二沉池及污泥处理。     

西安表土中多环芳烃的污染特征及其来源解析

通过2008年采集西安不同功能区表层土壤样品,运用GC/MS质谱联用仪对美国EPA优控的16种多环芳烃(PAHs)进行定性、定量分析,来探讨西安表层土壤种多环芳烃的污染特征及其来源。结果表明,16种PAHs均被检出,西安表土中ΣPAHs浓度范围为125~9 057 ng/g,平均值为2 727 ng/g,主要以4~6环PAHs为主,共占总量的69%。PAHs的空间分布规律为:工业区>文教区>绿化区>郊区>农村。应用特征比值判断法可知,西安表土中PAHs主要是煤的不完全燃烧和机动车尾气排放所产生的混合源污染。借鉴国外土壤污染标准可知西安城区表土污染较为严重。     

不同载体材料对厌氧氨氧化效果影响的研究

文章分别采用水性聚氨酯(WPU)和活性炭2种材料作为生物载体,在2个不同的上流式厌氧污泥床(UASB)反应器中接种包埋污泥和生物活性炭,采用人工配水进行连续实验,观测厌氧氨氧化反应器启动过程中各种含氮化合物的变化,以考察不同载体材料对厌氧氨氧化过程的影响。文章在生物活性炭反应器中成功驯化了采自污水处理厂的普通厌氧污泥,证明了从环境中驯化培养厌氧氨氧化菌的可能性。通过2个阶段中脱氮效率的比较,发现以水性聚氨酯包埋材料作为未驯化细菌载体并无明显优势,反而成为传质的障碍;而采用生物活性炭则可以迅速达到提高局部生物量、聚集功能菌、屏蔽不利环境的干扰等作用,是理想的微生物载体。     

Seasonal trend of ambient PCDD/Fs in Tianjin City, northern China using active sampling strategy

The spatial concentrations, seasonal trends, profiles and congener pairs of ambient polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) were investigated within a seasonally active sampling scheme during Jun 2008 and Jan 2009 in Tianjin City, northern China. The PCDD/F concentrations ranged 14.2-172 fg I-TEQ/m³ (average 69.3 fg I-TEQ/m³) in summer and (89.8-1.01) × 10³ fg I-TEQ/m³ (average 509 fg I-TEQ/m³) in winter, respectively, except for the E-waste dismantling site where much higher values were observed (1.04 × 10³ fg I-TEQ/m³ in summer and 7.123 × 10³ fg I-TEQ/m³ in winter). The results indicated a significantly seasonal trend with higher TEQ values in winter as compared with summer, which could be related to increased emission sources and seasonal variations of the atmospheric boundary layer height. 2,3,4,7,8-PeCDF was the dominant contributor to the total PCDD/F toxic equivalents, and 2,3,7,8-TCDD was detected at almost all the sampling sites in winter. Most of the similarly substituted PCDD/F congener pairs exhibited high correlations, suggesting that they might have similar environmental fate or sources. But different seasonal and spatial distributions of PCDD/F concentrations indicated that the emission sources might be intermittent.     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.